Di470
Solution
CAUSE:
Incorrect setting in tech rep mode.
SOLUTION:
If the original size detection option is not installed, please make sure it is not enabled in the Tech Rep mode. Go to Tech Rep Mode/System Input/Orig.Size
Option. It should be set to "OFF" unless the option has been installed.
Solution ID
1
Solution Usage
TAUS0642917EN*
Description
When attaching a card reader or coin unit to a Di550/Di450, the doc feeder and duplexer are disabled when using card or coin mode in the security settings.
They work if you use plug in counter mode, but when there is not enough money paid for the size of the job the machine jams.
Solution
CAUSE:
The Feeder and the Duplex unit are disabled because they require multiple vends to function. The manufacturer of the coin box or card reader must be
contacted to determine the signal on which the unit is basing its count.
Duplex copies are a 2 vend function (1 copy for the first side and 1 copy for the second). The machine sees this as 2 copies and these options are disabled
when the Vendor mode is set.
SOLUTION:
Set the vendor mode to "OFF" and just enable the key counter the unit should work properly with the coin box or card reader, depending on the
manufacturer's design.
Solution ID
1
Solution Usage
TAUS0643092EN*
Description
How to enter the adjust mode.
Solution
At the main Tech Rep Mode screen, press [stop], then [start].
Solution ID
1
Solution Usage
TAUS0643446EN*
Description
No selection for setting TCP/IP* address in Utility Mode.
Solution
CAUSE: Incorrect controller type and peripheral mode settings.
SOLUTION: On the Di470 the controller type must be set to 6 for the Pi4700e. With controller system 1 on the Pi4700e, the peripheral mode must be set to
1. With controller system 3 or higher, the peripheral mode must be set to 2 if the hard disk is installed or to 3 if the hard disk is not installed.
Notes:
1. For details on Pi4700e version 4 please see bulletin 4796 .
2. To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
Solution ID
1
Solution Usage
TAUS0643887EN*
Description
Intermittent C1499 service code when making copies.
Solution
CAUSE: The IR cooling fan (M52) fails to turn.
SOLUTION: Verify that CN152 and PJ4IC on the SCP (Scanner Control Board) are connected properly. If so, replace the M52 IR cooling fan motor (p/n
9313-1911-41). If by chance the issue is still unresolved, replace the Scanner CB (p/n 4002-0105-03).
Solution ID
1
Solution Usage
TAUS0644644EN*
Description
C004F immediately after replacing the PU1 power supply.
7
Copyright 2007, Konica Minolta Business Solutions U.S.A., I nc.
September 2007
(284 Seiten)
(162 Seiten)
(276 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern