Minolta CD-10 Installationsanleitung PDF herunterladen (Seite 12)

Installing Accessories8

Installing Accessories

Attention

Installing accessories always requires that the printer be turned off

and unplugged.

If you purchased any additional printer accessories (such as a duplex

option), then install them now. If installation instructions are included with

the accessory, follow them. If not, instructions are included in the

User’s

Guide

(in PDF on the

Utilities and Documentation

CD-ROM).

Plugging in/Turning on the Printer

Make sure the printer is turned off.

Plug the printer power cord into the printer and into a dedicated,

grounded, surge-protected electrical outlet.

In compliance with UL guidelines, “The appliance inlet is

considered to be the main disconnect device.”

Turn on the printer.

The Ready and Error indicators light up, and then, after 180 sec-

onds, the Error indicator turns off while the Ready indicator stays

on. If the indicators do not light up in this way, check the setup.

The printer automatically switches to power-saving (Energy Saver) mode

after 30 minutes of inactivity. Using the Status Display utility, you can

change the amount of time the printer waits before switching to power-sav-

ing mode.

(Refer to “Working with the Status Display” in the User’s Guide

)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Minolta CD-10 Installationsanleitung Seite 12